Ways To Detect Water Leaks and Avoid Costly Repairs

A little water leak may create a lot of damage to your home, and it usually stays unnoticed until it’s far too late, at which point it’s too late, and you’ll need to pay for expensive fixings. Ceilings, carpets, and walls can be expensive to restore. You’d be surprised to know that even minor repairs can cost thousands of dollars.

Things to Check to Prevent Water Damage

As a property owner, you must always know how to keep your property safe from water damage. We’ll show you how to prevent water damage in a few simple ways:

  1. Check your toilets.

Look for any water that shouldn’t exist on the floor. Remove the tank’s top and ensure that the float is adjusted to the correct level (typically indicated by the letters WL on the inside). So it is not overrunning into the overflow pipe. Usually, all it takes is a minor adjustment. Leak detection and repair can save you a lot of money and time.

2. Check your plumbing system.

Check your plumbing, particularly your water pipes, both inside and outside your home. Check the area around your sinks, basins, and cupboards. Check under your sink for puddles or leaks from your pipes; also, plug your sinks and fill them up, then remove the plug and look for leaks underneath. If there is any water under, try to find the source of the leak; it could be a simple dripping tap or a leaking waste that is easily repaired. In case you need help about this, search for emergency cleanup services.

3. Check your hot water cylinder.

Look for leaks, wet patches on the floor, or even small jets of water as you check the valve work. Also, make sure the water isn’t pouring out of the air vent on low-pressure open vented hot water cylinders.

4. Water valves.

Most importantly, make sure that you and your family know where to turn off the water in an emergency. Knowing where your water shutoff valve is located might save you thousands of dollars in the long run. There will usually be a shutoff valve in the front of your property (usually on the Council edge) with a blue cover to identify it if you have reticulated water (community supply). In addition, a water pump and the water tank shutoff valve should be switched off on the house with a non-reticulated water supply (your water comes from storage tanks).

5. Check your roof.

Check your roof and spout outside of your home for any problems. Regularly clean out all fallen leaves from your spouting, as blocked spouting, especially inner gutters, can cause significant water damage to your ceilings. Additionally, check roof penetrations such as chimneys and flues, especially flashings.

Loose nails or screws, broken flashings, or perhaps gaps under flashings are all signs of roof problems. Look for wet patches on your ceiling as well. Roof leaks, even little ones, can quickly cause severe ceiling and structural damage. Tek screws can replace loose nails, and Plumbers Roofing Silicone can be used to reseal flashings. Visit this website for more details about water damage restoration.


You must keep in mind that it is better to be safe than sorry. If you discover any indication of a water leak anywhere, no matter how small it appears to be, have it repaired right away or fix it yourself. You could put it off and ignore it, and then the small leak turns into a huge flood when you’re off shopping or on vacation.